The main component of the flat collector is a copper absorber with selective coating, which provides a high level of absorption of solar energy and low emission of thermal energy. Copper tube is installed at absorber and coolant flows through the former. It may be water or some non-freezing liquid, which takes heat from the absorber and simultaneously with circulating through the coil, it accumulates in the accumulation tank (the tank with water).
The absorber body is protected by a collector with a reinforced insulation that also minimizes heat loss. The amount of solar radiation that reaches the surface of the solar collector reaches its maximum only at noon when the sun is at its zenith. Speaking about morning and evening, sunlight falls on it at an angle, and the amount of absorbed solar radiation decreases.
Flat collectors do not work in winter, because even with a two-system` antifreeze, the maximum allowable operating temperature is about -5
{ 0 comments… add one now }